car repair austin texas
Wednesday, July 28th, 2010
Tour de Fat Car/Bike Swap Austin, Texas
Archive for the ‘Uncategorized’ Categoryengine computer repairTuesday, July 27th, 2010
Home Computer Repair – Do It Yourself?Home computer repair is not brain surgery! Most computer repairs can be broken down into two specific areas, software and hardware. Now I do admit that in some people’s hand, a screwdriver can be a dangerous object. But if you can change a light bulb without shocking yourself, I’d bet you could swap out a computer part. Software gets a little trickier but is still within the grasp of most computer users. I’ve been involved in computer repair in one way or another for over 25 years. The three major repairs I get called for on a weekly basis are: Spyware/Malware Issues All of these can be quite a challenge depending on the value and risk of losing important data, which can be anything from tax records to photos. Any computer can be repaired; it just depends on time and budget. But not all data can be rescued. If a hard drive suffers a catastrophic hardware failure, data recovery is doubtful (unless you want spend 100’s if not 1000’s of dollars for special services). So the best scenario in any home computer repair solution is have a good backup of your important data before you start any repair. I never work on anything for over an hour without immediately backing it up on another media (USB thumb drives are only about $30 for up to 5 gigs of storage and CD or DVD prices are under a buck). I learned the hard way very early in my computer using experience. It’s much easier to deal with any home computer repair if you don’t have to worry about important data. *Please, backup your data right after you finish this article and start doing it on regular basis. When you have a secure backup, the home computer repair is a matter of a little investigative work (to determine the real issue – sometimes Windows will point you in the wrong direction) and coming up with a good solution. Let’s look at the best way to prevent each of the three most common computer repairs and if you already have the problem, some possible solutions. Spyware/Malware – Two good preventive measures to eliminate Spyware and Malware is to keep your OS (normally Windows) up to date on security patches from your friends at Microsoft. This is pretty easy to do if you turn on Automatic Updating in your Security Center (go to Control Panel, click on Security Center, then check that Automatic Updates is turned on). The other is to make sure you have a good Anti-Virus software installed and it gets updated automatically. These two programs give you about a 93% solution. Another 5% can be addressed with Anti-Spyware software such as Windows Defender (free from Microsoft, just do a search for it on your choice of Search Engine) or Spybot, a free program from www.spybot.info that does a good job too. Where’s the last 2%, well there is no 100% solution I’m sorry to say. Although common sense on where you surf, what email you open, and where you click can generally keep you safe. What if you are already infected? Well, there are manual ways of removing Spyware/Malware programs but they aren’t pretty and involve a whole lot of searching around and rebooting in safe mode. If you search on the offender (normally most have a common problem) you can find a manual solution. If you would rather skip all that hassle, the most effective commercial program I’ve seen is SpySweeper. Last time I looked it was only $30 per year and could save you a lot of time and pain. You can find it here: www.webroot.com Hardware Failure – OK, not a lot of prevention available for this home computer repair. Keep in mind that most modern computer components have a 3-5 year mean failure rate. Depending on how much you use or leave your computer on each day, this time period can expand. I have several testing computers that are very old (plus 7 years) that don’t get used often. But one point I do want to make is that almost every customer I call on for a hardware failure issues had warning signs before the final crash. Strange noises, computer freezing up, frequent re-starts, etc. are causes for alarm. Don’t wait until the computer literally dies, if any of these events start occurring, go to the proactive mode and replace the power supply, hard drive, or ram. Which one? That’s a challenge, I’ve found that some diagnostic programs can be helpful, but a lot of the time it’s experience. Basic rules of thumb; Freezing, rebooting can be both flaky power supply and RAM going bad. Power supplies slowly loose ability to supply enough wattage, so if you run fine for the first 30 minutes that’s another tip it could be the power supply. RAM just gets flaky due to constant heating and cooling. It will usually start dying slowly too. Both are cheap to replace but the power supply has anywhere from 8 to 10 plugs you get to keep an eye on when changing out. Any power supply above 250 watt will be fine for most computers, 300 watt is better. Match the power supply or RAM exactly or look up the motherboard requirements if you want to jump up in speed or wattage. On hard drives, boot failure with the message “no operating system” or similar is almost always a controller or hard drive (some hard drives have controllers on them that go south too). When you go to save or copy files and get an error can also indicate a hard drive issue. Noises of any kind coming from your computer can only be the power supply fan or hard drive. Sometimes you can low level format a drive and bring it back but with the cost being so low on new hard drives, why take a chance. Boot Up Problems – Number one offender is Windows of any flavor. All versions use a “registry” to manage all software, user, and hardware settings. This is just a fancy database of settings but can easily destroy itself. Open files don’t close properly when there’s a software problem and there goes the database integrity. When you go to reboot, the registry is not readable or flat gone. In Windows XP, there are several files involved in the “hive” (5 to be exact). Any one of these can toast itself, but I always replace all five since they are so interdependent on settings. The easiest fix, if you can access the Recovery Console, is to find a usable set of back up files and copy them to the current area of access. This sounds pretty simple but the directory structure is fairly long and you have to unhide the backup locations. If you go to Microsoft’s knowledge base here you can read all about the Recovery Console and how to replace registry files: http://support.microsoft.com/search/?adv=1 . You can run the Recovery Console from Windows XP if it is installed or from your install CD if not. But what if you don’t have an install CD (many computers manufacturers don’t provide one anymore)? You can always use a bootable CD with an NTFS write enabled OS (like Linux) and do the same copying of files recommended in the Recover Console information. If that sounds too scary, you can always borrow some friends Windows XP install CD of the same flavor (Home or Pro) to use Recovery Console. OK, no friends have an install CD and no access or desire to Linux CD, now what? Well, plan B is to take your hard drive out of the computer, change the little connector on the back of the hard drive to slave (most hard drives have instructions right on the case to show how), and connect it to a working Windows XP computer. Now you have access to the drive with an NTFS write enabled OS. Go back to the instructions on Recovery Console fix and get after it. If the hard drive won’t even light up or spin, well then you get to install a new one. Most of the new units have a CD that will handle all the details of adding the new hard drive. Then you get to use your Recovery CDs from the manufacturer to install the all the original software on the new hard drive. Don’t have the restore disks? Check with the computer manufacturer and they’ll sell you a set for under $20 usually. Make sure you give the exact model number to get the right software for your unit. Whenever I buy a new computer, if I don’t get a set of recovery CDs, I order them right then and there. That way I’m ready for what ever happens. So, now you have the basics on home computer repair for the three most common problems. It’s not that hard for most people, just take it slow and read the instructions. Push comes to shove, find a friend who may have a little more experience to help. You buy the pizza and they provide a little experience and moral support. About the Author Suzuki GSX1400 ECU repair, MIL code C34, injector 3 output defect
engine repair questionsThursday, July 22nd, 2010
It will be odvious this is my first bike clutch! I am working on a 84 honda nighthawk 700. When I removed the clutch cover to begin diassembling the clutch there was quite a bit of oil in the case. The plates even seemd to be fairly saturated with engine oil. Is this normal? It there supposed to be oil inside the clutch case. yes normal. most all metric bikes have a wet clutch. + Ford spark plug thread repair + TIME-SERT BLOWN OUT SPARK PLUG REPAIR blow out thread repair
used car repair warrantiesThursday, July 22nd, 2010
Buying Used CarsThe demand for cars has dramatically increased over the past few years. Everyone needs a car, but most people cannot afford to purchase a brand new car. If you are also tight on budget, then buying a used car will not be a bad deal. A Raleigh used car is more economical than a new car. If you are planning to buy a used car, then you will have to do a lot of research. Otherwise you might be sold a defective or faulty car. There are car dealers who sell used cars that are in a good condition. You can also take along a mechanic or a used car expert with you when you are going to see the used car that is up for sale. The mechanic will tell you the condition of the car and whether it is a good idea to buy the car or not. He will also be able to find out any hidden damages or faults in the car. You can get a good used car for the smallest amount of money. Private sellers often advertise their cars in newspapers. You can check your newspaper to find a used car on sale in your locality. You might even be able to find a used car in a really good condition for a reasonable price. You can also approach a used car dealer, who thoroughly assesses the car before putting it for sale. Still, it is advisable to check the reputation of the car dealer before making a deal. You can also browse the Internet and find cheap Jacksonville used cars online. Though you cannot touch or see the cars online, you can compare and examine the cars. The best part is that you don’t have to go anywhere for the purpose. There are many websites displaying used cars for sale. You can also buy a used car through a public auction. Usually, these car auctions are arranged by the police or government institutions and are the ones that they had seized through repossession or confiscation. They sell cars that were seized from car owners who were unable to repay their loan amounts. People tend to buy the cheapest used car, and end up paying out more on the repairs. Nowadays, most car dealers conduct thorough tests on the used car before putting it for sale. These dealers also offer warranty to assure the quality of the used car. These warranties may range from a period of 6 months to one year. The condition of the used cars depends on the usage of the car and its maintenance by its previous owner. You must look for the used car that is best used by its previous owner. Used cars rarely come with the warranty of the original manufacturer. So, used cars certified by car dealers are a good option. By buying a certified used car, you can be satisfied that the car you are buying has been thoroughly inspected and is in condition to be given an extended warranty. These certified used cars also come with benefits like low loan rate, roadside assistance, free maintenance like oil changes and shuttle services. You can also buy a used car from a used car sale. In these sales, you have a variety of used cars that are up n display. You can find different models of cars, compare them and consider their prices. You also get a chance to examine the condition of the car in these sale centres. About the Author Author Bio: Unnecessary Used Car Repair Expenses Used Car Dealer Warran
engine repair for dummiesMonday, July 19th, 2010
Construction Careers – a Job Someone’s Got to DoThe construction worker is the backbone of society since the advent of human civilization. But not too many people seem to notice that. And the role of the construction worker extends as far as the eye can see. You wouldn’t be able to go to the hospital for unforeseen emergencies because it wouldn’t exist. And you wouldn’t be able to argue with your spouse on your iPhone on your way to work. Why? Because the road you are driving on wouldn’t exist. The job of the construction worker is one that is always forgotten unless, while you are on that iPhone, you run into a traffic jam caused by a construction route. It is rather sad when construction workers are blamed when all they are doing is what they have been told to do. But construction workers are responsible for bringing life to the cities that we dwell in, and for not only making them lively, but making them safe as well. There are different kinds of construction workers that offer us varying elements of peace of mind every day, without us even realizing it. Did you recently look at a real life monument or a beautiful building? Did you take a moment to stop and think of the labor of love that went into that structure to ensure you had a cozy fire to sit next to? Probably not. But the construction worker that was responsible for those unforgettable moments of yours is known as the bricklayer. This is a man that installs or repairs brick structures such as your chimney or fireplace, your walkway or driveway, or your beautiful brick home. This worker is no dummy. They need to be able to create and perform strict calculations, problem solve, conduct document interpretation for building layouts, and organize routines and tasks on a daily basis. If you have a fireplace in your home, you should think of the work of the construction worker that lent you your domestic warmth. Would you like to visit a jazz club? How about a dancing joint? Many people do across all age demographics and it is easy to understand why. Nightclubs and jazz clubs are a fun way to relax with some friends and unwind after a long week. Perhaps you are one of those that appreciate the joys of the disco ball and the dance floor. Next time you are on the dance floor enjoying all the fun a disco ball, consider what it took to ensure this ball was placed there for you. Disco balls are rotating spheroids that hang from the ceilings and produce a number of light reflectors at the people beneath them. To install a disco ball requires the labor of skilled engineers and construction workers to ensure the ball is not only hung properly so that it works efficiently, but that it is hung in a manner that will be safe for all patrons. It is great to enjoy with friends and family. But when you are doing that, it would be great to also acknowledge the knowledge, experience, wisdom and effort of the construction people. So when you are on your fancy iPhone telling all and sundry about the lousy traffic conditions caused by construction, remember these people are doing their job. The end result of a job well done by a construction worker results in the safety and well being of you and your dear ones. About the Author Learn more about Commercial steel building. And for recreation, why not buy Iphone UK and if it is not to strange, get a disco ball too.
|
